CERACOAT Gun Coating is not a traditional gun oil, it actually replaces any kind of oil on the gun. This product is a coating, based on liquid high-performance ceramics (no silicone & PTFE). Gun Coating is used as a care product with many advantages, but also as a technical tool such as in support of the sliding properties
and to prevent corrosion. Specifically to rifles, CERACOAT gun coating has the advantage that it is abrasion-resistant and cannot flow down as a result of gravity. CERACOAT gun coating is dry on the surface and can not be wiped off by hand. If the gun barrel covers by hand, the perspiration does not penetrate the coating and thus prevents corrosion.
CERACOAT Gun Coating on steel is a silky-matte finish and is colorless and odorless. Even older weapons have again a beautiful, intense look. CERACOAT gun coating can be applied on nearly all surfaces such as steel, wood (painted), rubber, plastic and cast iron. The direct application to gold and silver ornaments is also always possible. Active from -50°C to +750°C
Application: CERACOAT Gun Coating will be applied on the cleaned weapon. Metal parts should be degreased before application, so that the ceramic particles can adhere directly on the steel. Spray CERACOAT gun coating thin on the surface and distribute the product with a microfiber-towel so that a fine wet film comes into being. After that, CERACOAT gun coating dries from itself within 30min. After 2 hours it will be fully hardened. In case of using CERACOAT gun coating into the barrel, the barrel must be absolutely clean. Apply the CERACOAT gun coating with a cotton-plug and move the cleaning rod several times forward and backwards. For care-treatment of guns use the pump spray. For smaller parts and to reduce the trigger weight, you can apply some drops.
